Caple C602E Instalační manuál stáhnout pdf (Strana 13)

Revision 1.9 - 13 -

Figure 6 Sill cut-out – sideview

• Reinforce all rear sill cut-outs to maintain sill integrity.

• Some trailers are equipped with flat-bar reinforcements around the tail lights (eyebrows). In some

cases these reinforcements will have to be trimmed or notched to allow the platform to reach bed

level. The trimming and/or notching should be done after the gate is installed by raising the gate very

carefully until the platform just contacts the reinforcements. At this point you can determine the

amount of trimming or notching required. This keeps trimming to a minimum.

• On truck bodies or trailers with swing doors the forward edge of the platform may have to be trimmed

or notched to accommodate door lock rods or lock lugs. After gate installation raise the gate very

carefully until the platform just contacts the lock rods or lugs, determine the amount of notching or

trimming required. This process keeps the trimming or notching to a minimum.

IMPORTANT!!!

• A proper preparation of the truck/trailer is essential for a safe, effective and efficient installation

process and assures proper function of the lift gate without damage to truck/trailer or lift gate.

Never work under mount frame or platform without safety supports

Disconnect the truck batteries prior performing any welding.

To avoid interference with the

body, you may have to cut out

the back sill.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Žádné komentáře

Caple C602E Instalační manuál Strana 13