Caple CAFF21 Uživatelský manuál

Electric Mid Drive™ Installation and Assembly Instructions Crankset Drive System, Type 1 copyright 2012, EcoSpeed Inc. http://www.ecospe

assembly, slip the side plate over the ends of the pins then snap the clip into place in the grooves on the ends of the pins using needle nose pliers.

INSTALL THE MOTOR CHAIN COVER STEP 1: Install the motor chain cover using three M4 x 6mm button head screws. Before tightening the screws adjust t

MOUNT THE THROTTLE The EMD kits come standard with a thumb operat-ed throttle that mounts on the right side of the handlebars between the twist shi

CONNECT THE SYSTEM TOGETHER Connect all of the matching connectors in the system. The con-nectors are designed so that you can’t get it wrong. Each c

Speed Sensor. Two terminals in a flat three terminal shell. Connects to matching connector on the cadence sensor cable. Serial Port Interface. Flat 4

Electric Mid-Drive Unit Freewheeling Crank Set Electric Mid Drive Components

Electric Mid Drive Components Other Parts (battery not shown) Velociraptor Motor Controller

Congratulations on your purchase of EcoSpeed’s Electric Mid Drive™ Electric Assist System, the world’s best multi-speed, throttle operated, electric-a

8) Bottom bracket tool. Such as Shimano TL-UN74. (Standard bike repair tool. Availa-ble from almost any bike shop.) 9) Pin Spanner SPA-1 or Pin Span

Set the pedals aside. You will reinstall them on the new crank set supplied with your kit. STEP 2: Remove the left and right cranks and chainrings.

STEP 2: Insert the bottom bracket cartridge from the left side. Note that some are not sym-metric. If so, insert so that the side with the longer axle

STEP 4: Re-attach the right side ring to the EMD frame using the bolts, nuts, and washers removed at step 1 in the previous section. Tighten bolts and

STEP 1: Thread two small cable ties through the small oval holes in the cadence sensor backing plate on the left side of the unit as shown in Photo 10