Caple C891C Specifikace

02/12 EINS 515736For use in GB and IELEAVE WITH CUSTOMERAGA 13 AMP RETRO-FIT WITH AIMS(OIL TO ELECTRIC)FITTING INSTRUCTIONS

INSTALLATION SHEET 4FIG. 1 REMOVE CABLE CLAMP. ATTACH MAINS CABLEFIG. 2 FIX CABLE CLAMP TO CONTROLS PANELFIG. 3 ROUTE THERMOCOUPLE THROUGH NOTCH

INSTALLATION SHEET 5FIG. 1 POST 2000 STAT PHIAL PRE 2000 STAT PHIALSUPPORT BRACKET SUPPORT BRACKETFIG. 2A POSITION THEROCOUPLE (10mm SPA

12For further advice or information please contactyour local distributor/stockistWith AGA-Rangemaster’s policy of continuousproduct improvement, the C

2l ISOLATE ELECTRIC SUPPLY, OIL SUPPLY AND WATER SUPPLY (BOILER MODELS), BEFORE COMMENCING WORK.BOILER MODELS (OCB AND OEB)IMPORTANT NOTE: The boiler

3DE-COMMISSION OIL SUPPLY AND REMOVE OIL CONTROLS1. Turn off oil supply, disconnect supply to appliance (preferably outdoors) and cap off. Turn on sup

4FIT STAINLESS STEEL TUNNEL1. Fit new stainless steel tunnel (between barrel and roasting oven).2. Replace barrel (use new graphite barrel gasket and

511. Fix mains cable through cable clamp. Fix cable clamp to control panel (See Installation Sheet 4, Figs. 1 and 2).12. Attach mains wiring to contro

6ELECTRICALWARNING: THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING PLATE, WHICH IS SITUATED ONTHE TOP

INSTALLATION SHEET 1FIG. 1 OIL CONTROLS TO BE REMOVED FIG. 2 CAP OFF OIL SUPPLYFIG. 3 FIT NEW ROPE SEAL FIG. 4 FIT TUNNEL BETWEEN BARREL &

INSTALLATION SHEET 2FIG. 1 DRILL AND TAP HOLE (M6) FIG. 2 OPEN OUT HOLE INTO OVENFIG. 3 MODIFY HOLE FOR FLEX CONDUIT FITTING FIG. 4 FIT LOCATIO

INSTALLATION SHEET 3FIG. 1 FIG. 2 FIT INSULATION BLANKETFIG. 3 FIXINGS FOR CONTROL BACK COVER FIG. 4 FIG. 5 M5 STUD FITTED TO BURNER D