Caple C891C Specifikace stáhnout pdf (Strana 5)

11. Fix mains cable through cable clamp. Fix cable clamp to control panel (See Installation Sheet 4, Figs. 1 and 2).

12. Attach mains wiring to control panel.

13. Outside the appliance route mains cable through ‘P’ clips provided, and attach to hank bushes on side panel (See

Installation Sheet 5, Fig. 5).

14. See ‘Electrical’ and ‘Electrical Test Procedure’ sections.

PAD BELOW SIMMERING PLATE

(See Installation Sheet 1, Fig. 8)

1. Remove simmering plate.

2. Fit new insulation pad on RH side of weir (ridge below simmering plate), as shown.

This must block off the flue passage. Take care, do not block off the vent hole in the top of the roasting oven.

FLUE SHROUD AND BLANKING PLATE

(See Installation Sheet 4, Figs. 4 - 7)

1. Remove flue shroud and remove flue baffle plate.

2. Fit new flue box blanking plate assembly, as follows:-

a) Remove front (RH) fixing from flue box.

b) Feed blanking plate assembly into place with raised part at rear.

c) Replace front fixing using a large washer and longer bolt (provided) to hold plate down.

d) Put thin layer fire clay around edges of blanking plate.

e) Attach mesh to rear flue shroud using silicone. (Align slot in mesh with second slot from top of flue shroud).

f) Position flue shroud over flue box so that lever arm projects through second slot from top.

g) Lever should move freely from left to right. Put lever in left hand position (vent closed).

MODIFY HOTCUPBOARD (4-OVEN MODELS ONLY)

1. Remove warming plate from top of hot cupboard (4-oven cookers only).

2. Fit blanking plate to LH side. Drill 2 holes for self-tap screws. (See Installation Sheet 5, Fig. 6).

3. Place 2 pads on top of hot cupboard. (See Installation Sheet 5, Fig. 7).

4. Replace warming plate, using new sealing strips.

HEAT INDICATOR PLATE, INSTRUCTION PLATE AND DATA PLATE

1. If the heat indicator plate is numbered either 4, 5 or 6, then swap the plate for one which is two numbers lower (either

1, 2 or 3).

2. Remove instruction plate from outer burner door (if fitted) and reverse the plate (See Installation Sheet 5, Fig. 3).

3. Write original cooker serial number onto data label.

4. Attach data plate label top LH side of control back cover (See Installation Sheet 5, Fig. 4).

5. Record the serial number of the cooker and refer this serial number to Service Centre.

CHECK LEVELS AND RE-BUILD

1. Replace simmering plate and boiling plate, check level and adjust as necessary.

2. Refill with vermiculite and fit new top plate blanket, and re-fit top plate.

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Caple C891C Specifikace Strana 5