Caple C871i Uživatelský manuál stáhnout pdf (Strana 428)

Apple II Computer Info

#############################################################################

### FILE : RGB.repair

#############################################################################

### Created : Sunday, January 14, 1996 Modified: Sunday, January 14, 1996

### File Type: "TEXT" File Creator: "LMAN"

### File Size: 3911 bytes 3 KB

#############################################################################

Newsgroups: comp.sys.apple2

Path:

news.weeg.uiowa.edu!news.uiowa.edu!uunet!europa.eng.gtefsd.com!paladin.american.ed

u!howland.reston.ans.net!cs.utexas.edu!utnut!helios.physics.utoronto.ca!neufeld

From: [email protected] (Christopher Neufeld)

Subject: Re: Bouncing screen...

Message-ID: <[email protected]>

Sender: [email protected] (News Administrator)

Organization: University of Toronto Physics/Astronomy/CITA

References: <[email protected]>

Date: Mon, 24 Jan 1994 06:55:32 GMT

Lines: 71

In article <[email protected]>,

<[email protected]> wrote:

>>The screen on my IIgs monitor (standard Apple issue) has begun to bounce

>>from top to bottom a bit shortly after I turn it on. If I thump the sides

>>the problem usually goes away, but that doesn't seem like a good long-term

>>solution. Any helpful advice will be appreciated.

>I have the exact same problem with my GS monitor as does Dr. Quack! The fix is

>simple! We hit it.

>Is this "doom bearing down" on the monitor?

If it's what I think it is, then yes, it is doom bearing down. One day

that monitor is going to die for good, and that day may be sooner than

you would like. I'm including the fixup procedure here, courtesy of Ian

Schmidt. I fixed my monitor successfully this way. Needless to say, don't

do this if you don't know what you're doing. If there's any doubt, bring

the monitor and this procedure to a person who has experience soldering.

--- BEGIN INCLUDED FILE ---

Opening up the RGB is a bit nasty, but not TOO bad. remove the 4 screws on

the back: (the one on the bottom doesn't matter).

___________

| @ @ |

| |

|___________|

| @ @ |

~~~~~~~~~~~

Next, carefully pull on the back a little, making sure to feed the power cord

thru the hole in the case. After not too long, the case will be caught on 2

different connectors. The first one is from the power switch to the left side

(facing from the back still) of the main board. Go ahead and unplug it (both

connectors you need to remove are keyed so they only go one way :). The case

will then pull off a bit more and you can (carefully) remove the cable from

Apple II Computer Technical Information : Apple II Family Hardware Info

ftp://ground.ecn.uiowa.edu/2/apple2/miscinfo/hardware : May 2001 : 428 of 572

1 2 ... 423 424 425 426 427 428 429 430 431 432 433 ... 571 572

Caple C871i Uživatelský manuál Strana 428

Komentáře k této Příručce

Caple C871i Uživatelský manuál Strana 428

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Caple C871i