Caple C871i Uživatelský manuál Strana 57

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 572
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 56
Apple II Computer Info
reboot." Allow 5-10 seconds for power unit to
warm up; get basic prompt ], then do "PR#n"
with n being the slot number of your launching
disk drive. Typically this is PR#7 or PR#6.
ARE INTERFACE CARDS 1. Remove all interface cards, and boot-up the
INCOMPATIBLE WITH computer. If boot succeeds, then add
interface
POWER SUPPLY UNIT? cards one at a time, booting up. Fussy
interface
card will make computer crash. This procedure
identifies any problem interface card.
MEASURED VOLTAGES SEEM 1. Orange +5v, yellow +12v, green -12v, blue -5v.
TOO LOW. As a safety feature, the output voltages are
normally LESS than these values when measured
without full load attached. When connected to
computer motherboard load, voltages will reach
their expected target values.
HOLES IN BACK OF IIGS 1. Note that there are two holes at rear of CPU
CASE ARE TOO SMALL case behind location of internal power supply.
TO THREAD CABLE TO Use thin-nose pliers to remove small amount of
MOTHERBOARD CONNECTOR; thin plastic around the larger (rectangular).
MOLEX-7 PLUG IS TOO BIG. hole. Then Molex-7 plug and cable will pass
through.
CLEAR SILICON CAULK 1. Clear silicon caulk was added to reduce strain
ON IIGS OR IIE CABLE on individual wires. IT IS FLEXIBLE. Slowly
PLUG SEEMS TOO STIFF bend the power cable after threading it into
TO MAKE RIGHT-ANGLE the CPU case; it will fit successfully on the
BEND TO CONNECT TO motherboard male connector.
MOTHERBOARD.
CABLE MOLEX-7 PLUG 1. Shine bright light into CPU. Be sure that
WON'T MATE WITH MALE Molex-7 plug is correctly centered on mother-
MOTHERBOARD CONNECTOR. . The polarizing-key in plug's third hole
prevents Molex-7 plug from being inserted
off-center. Polarizing-ramp on IIgs plug must face the slots. With IIe
version, the AMP-6 plug's two black wires must be positioned closest to
the keyboard
(front) side of the CPU.
COOLING FAN IS NOISY. 1. This is a normal feature of IBM-style power
units. Some sound like vacuum cleaners'
cousins!
Take advantage of the 5 ft cable to position
the
unit under your computer table, away from
ears.
2. If sound suggests that an object has fallen
into
the unit through a fan opening, SHUT OFF the
unit
immediately and shake unit so object will fall
out. Disconnect AC power, open unit, remove
item.
3. Most units generate no heat when used with
Apples, so the fan speed can be slowed with
Apple II Computer Technical Information : Apple II Family Hardware Info
ftp://ground.ecn.uiowa.edu/2/apple2/miscinfo/hardware : May 2001 : 57 of 572
Zobrazit stránku 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 571 572

Komentáře k této Příručce

Žádné komentáře